Accumulator Tank - Caravan - Bus - RV

$ 65.00
Model Number: FLATRED
Inlet/Outlet size: 1/2 inch
Size (cm): 15.0 x 10.4 x 10.4cm
Weight (kg): 0.7kg
Liquid to be pumped: Clean Water

This compact 1.5 litre pre-pressurised accumulator/pressure tank will fit into a tight space. It will give you a smoother water flow, quieter operation, will save your battery power and will extend the life of your pump. Perfect for fresh or grey water. A must for every caravan set up! Tank comes complete with a T-piece fitting to cut into your existing line and instructions.

 This quality enamel tank will hold a store of pressurised water to reduce unnecessary pump cycling, pulsation and water hammer when installed between the pump and the tap. It can also be used to moderate the flow to match your Hot Water Service. It can be fitted to new or existing pump system installations.

This accumulator tank is designed for use with any system controlled by a pressure switch.


Caravans, Buses, R'V's, Cabins and small homes where a pressure switch is on your water pump

  • Fully sealed
  • Easy to install and operate
  • Will align with your pumps PSI rating
  • Made from tough durable materials
  • Non corrosive enamel outer casing
  • Internal rubber membrane eliminates maintenance
  • Enamel exterior
  • Non toxic Butyl rubber diaphragm
  • Brass Valve
  • NOT for use with smart Sensor or sensor Max pumps
  • 1/2" BSP male thread on tank
  • Supplied with 1/2" female BSP T-piece with two barbed ends