fbpx

Accumulator Tank - Caravan - Bus - RV

$ 65.00
Model Number: FLATRED
Inlet/Outlet size: 1/2 inch
Size (cm): 15.0 x 10.4 x 10.4cm
Weight (kg): 0.7kg
Liquid to be pumped: Clean Water

Compact 1.5 litre caravan accumulator tank (pressure tank) will fit into a tight space. The accumulator tank will give a smoother water flow, quieter operation, will save your caravan battery power and will extend the life of your water pump. Perfect for fresh or grey water. A must for every caravan set up! Pressure tank comes complete with a T-piece fitting to cut into your existing line and instructions.

This quality enamel accumulator tank will hold a store of pressurised water to reduce unnecessary pump cycling, pulsation and water hammer when installed between the pump and the tap. It can also be used to moderate the flow to match your Hot Water Service. It can be fitted to new or existing pump system installations.

This accumulator tank is designed for use with any system controlled by a pressure switch.

Your accumulator tank comes pre-pressurised at 10 PSI ready to use. Your pressure tank can be pressurised by our staff to fully compliment the water pump setup it is going into. For a pressure tank to suit your caravan for potable water please click here.

EG: Your Escaping Outdoors F40 pump operates at 40PSI. We can pressurise the accumulator tank to our recommended 32 PSI to match your pump.

For our complete range of pressure tanks in many sizes (also called accumulator tanks as they accumulate water) click on this link.

Application

Caravans, Buses, R'V's, Cabins and small homes where a pressure switch is on your water pump

Features
  • Fully sealed
  • Easy to install and operate
  • Will align with your pumps PSI rating
  • Made from tough durable materials
  • Non corrosive enamel outer casing
  • Internal rubber membrane eliminates maintenance
  • Enamel exterior
  • Non toxic Butyl rubber diaphragm
  • Brass Valve
  • NOT for use with smart Sensor or sensor Max pumps
  • 1/2" male BSP thread on tank
  • Supplied with 1/2" female BSP T-piece with two barbed ends